On May 11, 2021, at 5:19 PM, Jersey Bob <k2q...@gmail.com> wrote:
I am looking for a case or stand to display my
nano Kenbak. Looking for ideas. Regrads, Bob
--
You received this message because you are subscribed to the Google Groups "uKenbak-1" group.
To unsubscribe from this group and stop receiving emails from it, send an email to ukenbak-1+...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/ukenbak-1/87417467-c213-46ad-9136-f07635e943f5n%40googlegroups.com.
You received this message because you are subscribed to a topic in the Google Groups "uKenbak-1" group.
To unsubscribe from this topic, visit https://groups.google.com/d/topic/ukenbak-1/pCSvx43sJsI/unsubscribe.
To unsubscribe from this group and all its topics, send an email to ukenbak-1+...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/ukenbak-1/f88556c3-f055-4408-90fe-70c51dfcfb5an%40googlegroups.com.
I can't believe it took me four tries to get this to print correctly. The first time I discovered the firmware on the new 4.2.7 controller doesn't support pause at layer/height correctly. The second time I sliced the model into three layers, bottom, letters, top. The first two layers went well but the to top wasn't aligned correctly. The third time I was so focused on alignment I forgot to swap out the filament for the letters. Fourth time was the charm. Thanks for the .stl file Mike. :)
--
You received this message because you are subscribed to the Google Groups "uKenbak-1" group.
To unsubscribe from this group and stop receiving emails from it, send an email to ukenbak-1+...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/ukenbak-1/af30716d-2cc2-4c4f-8180-c995271a86e6n%40googlegroups.com.