5mL syringe holder

[anmo...@colorado.edu]

Has anyone used a >3mL syringe and designed a new 3D printed holder for it? If so, would you mind sharing your design? I figure before I go ahead an design one myself, I'd ask the group and possibly save myself the time.

-Andrew

[Chris Takahashi]

I have not but, fun fact, the same part works with 1ml syringes.  (thats why there's two notches in the center.)

If you're feeling particularly lazy you could probably trim down the plunger end of a syringe to fit ;)

On Fri, May 5, 2017 at 2:58 PM, <anmo...@colorado.edu> wrote:

Has anyone used a >3mL syringe and designed a new 3D printed holder for it? If so, would you mind sharing your design? I figure before I go ahead an design one myself, I'd ask the group and possibly save myself the time.

-Andrew

--
You received this message because you are subscribed to the Google Groups "Mixture Controlled Turbidostat" group.
To unsubscribe from this group and stop receiving emails from it, send an email to mixture-controlled-turbidostat+unsubscribe@googlegroups.com.
To post to this group, send email to mixture-controlled-turbi...@googlegroups.com.
Visit this group at https://groups.google.com/group/mixture-controlled-turbidostat.
For more options, visit https://groups.google.com/d/optout.

[Andrew Morgenthaler]

I was wondering what those two notches were for!

I've been cutting off the ends of the plunger to allow it to fit into the syringe slide, but the diameter of the actual syringe is too big for the current syringe mount. So I'm in need of a syringe mount that can fit a wider syringe bore.

On Fri, May 5, 2017 at 5:51 PM, Chris Takahashi <chris.t...@gmail.com> wrote:

I have not but, fun fact, the same part works with 1ml syringes.  (thats why there's two notches in the center.)

If you're feeling particularly lazy you could probably trim down the plunger end of a syringe to fit ;)

On Fri, May 5, 2017 at 2:58 PM, <anmo...@colorado.edu> wrote:

Has anyone used a >3mL syringe and designed a new 3D printed holder for it? If so, would you mind sharing your design? I figure before I go ahead an design one myself, I'd ask the group and possibly save myself the time.

-Andrew

--
You received this message because you are subscribed to the Google Groups "Mixture Controlled Turbidostat" group.

To unsubscribe from this group and stop receiving emails from it, send an email to mixture-controlled-turbidostat+unsub...@googlegroups.com.
To post to this group, send email to mixture-controlled-turbidostat@googlegroups.com.

Visit this group at https://groups.google.com/group/mixture-controlled-turbidostat.
For more options, visit https://groups.google.com/d/optout.