Mixture Controlled Turbidostat

Thanks Chris for the quick reply, I will go ahead and try the design with one of the new lasers,

Great maybe I'll give this a try. What size syringe do you recommend? On Tue, Dec 4, 2018 at 4:42

Are you able to program the mainboard? Unfortunately, It sounds like it's either the

It looks like you need to connect the 12v motor supply on the mainboard (see photo): On Tuesday,

You can conformal coat the boards if you want. They sell a few different formulations in spray cans.

Looks like the new firmware works. The motor stops straining after ~2s. I just tested this by

The computed dilution rate would be zero, but there's a parameter for the minimum. The dilution

I was wondering what those two notches were for! I've been cutting off the ends of the plunger to

No changes needed. The software will still take a short pause to wait for servos to move but that won

Thanks Chris, this worked! On Thursday, April 27, 2017 at 4:52:04 PM UTC-4, Chris Takahashi wrote:

Yeah the more I think about it, the more I think the issue is the flocs. I'm working with a

Yep. Plugging solenoid valves into positions 1-8 should "just work" (for 12v solenoid pinch

In theory to get the same Kp an Ki values you'd have to scale them by the same factor of syringe

If the valves are already closed you'll see no effect by typing clo;. The commands do not output

I can't send PDFs but I have a limited number of "e-prints" that I can send. check your