Regarding infill percentage
39 views
Skip to first unread message
Benas Molis
Feb 10, 2019, 7:11:51 AM2/10/19
to Cyclone PCB Factory
Hello,
I have 3D printed all Cyclone PCB Factory's V2 parts using PLA Filament at 20% infill as it was recommended by Carlos in one the posts. What infill should I use for Dremel 200 Z carriages?
Best regards,
Ben.
I have 3D printed all Cyclone PCB Factory's V2 parts using PLA Filament at 20% infill as it was recommended by Carlos in one the posts. What infill should I use for Dremel 200 Z carriages?
Best regards,
Ben.
Carlos García
Feb 12, 2019, 1:31:25 AM2/12/19
to cyclone-p...@googlegroups.com
50% infill is a good choice
--
You received this message because you are subscribed to the Google Groups "Cyclone PCB Factory" group.
To unsubscribe from this group and stop receiving emails from it, send an email to cyclone-pcb-fac...@googlegroups.com.
To post to this group, send an email to cyclone-p...@googlegroups.com.
Visit this group at https://groups.google.com/group/cyclone-pcb-factory.
To view this discussion on the web, visit https://groups.google.com/d/msgid/cyclone-pcb-factory/7f1c6721-adc7-47f1-a483-b722e34493f6%40googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
Reply all
Reply to author
Forward
0 new messages