Unijoysticle 2 and DualShock3 pairing

[Bart Pellens]

Hi,

I can't seem to get the my official PS DualShock3 to connect, so I hope I can get some pointers here.

I followed the github instructions to the letter (manual pairing - adding the MAC address to the DS3, etc.), but the DualShock3 just doesn't want to connect - the 4 leds on the DS3 stay blinking, nothing more.

Using a Wii controller works just fine, so I know that the UniJoysticle2 works fine.

In the Unijoysticle2 trace I see that the DS3 connection is complete (after pressing the PS button on the DS3), yet the 4 leds of the DS3 stay blinking and I can't control anything on my C64.

What I see in the logs (red part):

Bluepad32 (C) 2016-2021 Ricardo Quesada and contributors.

Version: v2.0.0-beta2

BTStack: Copyright (C) 2017 BlueKitchen GmbH.

unijoysticle: Dual port / 1-button mode enabled

Platform: unijoysticle2

Gap security level: 2

I (282) system_api: Base MAC address is not set, read default base MAC address from BLK0 of EFUSE

I (392) phy: phy_version: 4180, cb3948e, Sep 12 2019, 16:39:13, 0, 0

BTstack up and running on FC:F5:C4:3D:55:B2.

Stored link keys:

00:24:F3:E5:5B:02 - type 0, key: .

--> Scanning for new devices...

--> HCI_EVENT_COMMAND_COMPLETE: opcode = 0x200b - status=0

--> GAP_EVENT_INQUIRY_COMPLETE

--> Scanning for new devices...

--> GAP_EVENT_INQUIRY_COMPLETE

--> Scanning for new devices...

--> GAP_EVENT_INQUIRY_COMPLETE

--> Scanning for new devices...

--> HCI_EVENT_CONNECTION_REQUEST: link_type = 1 <--

on_hci_connection_request from: address = 00:26:43:97:AB:93, cod=0x0508

--> HCI_EVENT_ROLE_CHANGE

--> HCI_EVENT_CONNECTION_COMPLETE

--> HCI_EVENT_COMMAND_COMPLETE: opcode = 0x040c - status=0

--> HCI_EVENT_PIN_CODE_REQUEST

Using PIN code:

--> HCI_EVENT_COMMAND_COMPLETE: opcode = 0x040d - status=0

--> GAP_EVENT_INQUIRY_COMPLETE

--> Scanning for new devices...

Best Regards,

Bart

[Ricardo Quesada]

Hi Bart,

DS3 support is disabled by default.

You have to edit this file:
https://gitlab.com/ricardoquesada/bluepad32/-/blob/master/src/main/uni_config.h#L31

and enable DS3 from there.
Then re-compile (make clean && make -j) and flash the firmware

> --
> You received this message because you are subscribed to the Google Groups "Unijoysticle" group.
> To unsubscribe from this group and stop receiving emails from it, send an email to unijoysticle...@googlegroups.com.
> To view this discussion on the web visit https://groups.google.com/d/msgid/unijoysticle/de78dd19-c148-44ca-a7c7-e8645491e4d4n%40googlegroups.com.