Just a first guess:
_Mark
Isaac --
You received this message because you are subscribed to the Google Groups "OpenPnP" group.
To unsubscribe from this group and stop receiving emails from it, send an email to openpnp+u...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/openpnp/a3f13b96-991b-4f60-921c-f24f66f7b2c9n%40googlegroups.com.
please post a log at TRACE level and machine.xml
To view this discussion on the web visit https://groups.google.com/d/msgid/openpnp/28a754bd-d6d8-4a0c-b029-d24da59bafc9n%40googlegroups.com.
<reported-axes><![CDATA[ok C: X:100.0000 Y:100.0000 Z:0.0000]]></reported-axes>
This likely means you did not configure it properly in the Smoothieware config.txt
So send the config.txt
(I'm not the Smoothie expert per se, but maybe the error is
obvious 😁, or other users can have a look
and help)
_Mark
To view this discussion on the web visit https://groups.google.com/d/msgid/openpnp/59ba1f68-68ba-49c4-bee4-44ca1382a98fn%40googlegroups.com.
I guess Smoothie does not like skipping axes. You have the A axis
on the epsilon instead of the delta, and the delta
is left undefined (if I remember correctly, assigning pins is
actually enabling the axis).
#Y2(M4) delta_current 1.5 # First extruder stepper motor current #C axis (M5) epsilon_steps_per_mm 800 # Steps per mm for extruder stepper epsilon_step_pin 2.8 # Pin for step signal epsilon_dir_pin 2.13 # Pin for dir signal ( add '!' to reverse direction ) epsilon_en_pin 4.29 # Pin for enable signal epsilon_current 1.5 # Second stepper motor current a_axis_max_speed 6000 # Maximum speed in mm/min epsilon_max_rate 300 # mm/s epsilon_acceleration 500 # Acceleration for the stepper motor, as of 0.6, arbitrary ratio
I assume you want to configure two Y axes, that are paired, i.e. use the same logical Y axis, same step/dir pulses, but you want to use two (i.e. the beta and delta) stepper drivers. I don't know how to do that.
Smoothie users, please help!
_Mark
To view this discussion on the web visit https://groups.google.com/d/msgid/openpnp/7ef822df-9e81-40d5-8a68-148121071981n%40googlegroups.com.
Yeah, I guess it would make sense to swap them.
But you still need to drive the epsilon / Y2 pins with the same logical axis as the beta / Y pins.
It seems this is only possible using physical jumper wires, look
for "Doubling stepper motor drivers" here:
http://smoothieware.org/general-appendixes#doubling_stepper_motor_drivers
But if I'm not mistaken you would use beta as the source
(not gamma) and epsilon as the destination of the
jumper wires.
_Mark
To view this discussion on the web visit https://groups.google.com/d/msgid/openpnp/c90e809c-b874-48b7-956b-6d0d55e08dcfn%40googlegroups.com.