Why would they won't work after bind phase? unlike tcon top gates,
these reset, and bus are common like what we have in other DE block
so enable them in bind won't be an issue as per as I understand. let
me know if you want me to check in other directions.
Log:
[ 1.381410] sun6i-mipi-dsi 1ca0000.dsi: Attached panel s070wv20-ct16-icn62
[ 1.398405] sun4i-drm display-engine: bound 1100000.mixer (ops 0xc074ce64)
[ 1.407134] sun4i-drm display-engine: bound 1200000.mixer (ops 0xc074ce64)
[ 1.414043] sun4i-drm display-engine: bound 1c70000.tcon-top (ops 0xc0750e80)
[ 1.421407] sun4i_dclk_recalc_rate: val = 1, rate = 297000000
[ 1.427358] sun4i-drm display-engine: No panel or bridge found...
RGB output disabled
[ 1.435217] sun4i-drm display-engine: bound 1c71000.lcd-controller
(ops 0xc0749594)
[ 1.442891] 0.0 drm_connector_init
[ 1.446294] 0. -1066106880-1-0 (null)
[ 1.449965] 0.1 drm_connector_init
[ 1.453368] 0.2 drm_connector_init
[ 1.456768] 1. drm_connector_init
[ 1.460094] 2. drm_connector_init
[ 1.463413] drm_connector_init: connector name = DSI-1
[ 1.468560] sun4i-drm display-engine: bound 1ca0000.dsi (ops 0xc074c0e4)
[ 1.475272] [drm] Supports vblank timestamp caching Rev 2 (21.10.2013).
[ 1.481892] [drm] No driver support for vblank timestamp query.
[ 1.488240] [drm] Initialized sun4i-drm 1.0.0 20150629 for
display-engine on minor 0
[ 1.497996] sun4i_dclk_round_rate: min_div = 6 max_div = 6, rate = 30000000
[ 1.498106] ideal = 1800000, rounded = 180000000
[ 1.498111] sun4i_dclk_round_rate: div = 6 rate = 29700000
[ 1.498116] sun4i_dclk_round_rate: min_div = 6 max_div = 6, rate = 30000000
[ 1.498154] ideal = 1800000, rounded = 180000000
[ 1.498158] sun4i_dclk_round_rate: div = 6 rate = 29700000
[ 1.498217] sun4i_dclk_recalc_rate: val = 1, rate = 178200000
[ 1.498251] rate = 178200000
[ 1.498253] parent_rate = 297000000
[ 1.498256] reg = 0x80c00000
[ 1.498259] _nkm.n = 3, nkm->n.offset = 0x1, nkm->n.shift = 8
[ 1.498262] _nkm.k = 2, nkm->k.offset = 0x1, nkm->k.shift = 4
[ 1.498265] _nkm.m = 10, nkm->m.offset = 0x1, nkm->m.shift = 0
[ 1.499594] sun4i_dclk_set_rate div 6
[ 1.499603] sun4i_dclk_recalc_rate: val = 6, rate = 29700000
[ 1.499680] sun6i_dsi_get_video_start_delay: delay = 513
[ 1.499687] sun6i_dsi_setup_inst_loop: delay = 49
[ 1.499706] hsa = 134, hbp = 114, hfp = 114, hblk = 2630, vblk = 0
[ 1.509103] mmc0: host does not support reading read-only switch,
assuming write-enable
[ 1.512693] mmc0: new high speed SDHC card at address 4001
[ 1.513723] mmcblk0: mmc0:4001 R04GS 3.71 GiB
[ 1.515577] mmcblk0: p1 p2
[ 1.658838] mmc2: new DDR MMC card at address 0001
[ 1.659934] mmcblk2: mmc2:0001 8WPD3R 7.28 GiB
[ 1.660657] mmcblk2boot0: mmc2:0001 8WPD3R partition 1 4.00 MiB
[ 1.661387] mmcblk2boot1: mmc2:0001 8WPD3R partition 2 4.00 MiB
[ 1.819586] TYPE#0x23, BYTE0#0x7a00, BYTE1#0xc10000
[ 1.849570] TYPE#0x23, BYTE0#0x2000, BYTE1#0x200000
[ 1.879569] TYPE#0x23, BYTE0#0x2100, BYTE1#0xe00000
[ 1.909580] TYPE#0x23, BYTE0#0x2200, BYTE1#0x130000
[ 1.939569] TYPE#0x23, BYTE0#0x2300, BYTE1#0x280000
[ 1.969569] TYPE#0x23, BYTE0#0x2400, BYTE1#0x300000
[ 1.999569] TYPE#0x23, BYTE0#0x2500, BYTE1#0x280000
[ 2.029569] TYPE#0x23, BYTE0#0x2600, BYTE1#0x0
[ 2.059569] TYPE#0x23, BYTE0#0x2700, BYTE1#0xd0000
[ 2.089598] TYPE#0x23, BYTE0#0x2800, BYTE1#0x30000
[ 2.119579] TYPE#0x23, BYTE0#0x2900, BYTE1#0x1d0000
[ 2.149569] TYPE#0x23, BYTE0#0x3400, BYTE1#0x800000
[ 2.179569] TYPE#0x23, BYTE0#0x3600, BYTE1#0x280000
[ 2.209569] TYPE#0x23, BYTE0#0xb500, BYTE1#0xa00000
[ 2.239569] TYPE#0x23, BYTE0#0x5c00, BYTE1#0xff0000
[ 2.269569] TYPE#0x23, BYTE0#0x2a00, BYTE1#0x10000
[ 2.299569] TYPE#0x23, BYTE0#0x5600, BYTE1#0x920000
[ 2.329578] TYPE#0x23, BYTE0#0x6b00, BYTE1#0x710000
[ 2.359569] TYPE#0x23, BYTE0#0x6900, BYTE1#0x2b0000
[ 2.389569] TYPE#0x23, BYTE0#0x1000, BYTE1#0x400000
[ 2.419569] TYPE#0x23, BYTE0#0x1100, BYTE1#0x980000
[ 2.449569] TYPE#0x23, BYTE0#0xb600, BYTE1#0x200000
[ 2.479569] TYPE#0x23, BYTE0#0x5100, BYTE1#0x200000
[ 2.509569] TYPE#0x23, BYTE0#0x900, BYTE1#0x100000
[ 2.679570] TYPE#0x5, BYTE0#0x2900, BYTE1#0x940000
[ 2.767213] Console: switching to colour frame buffer device 100x30
[ 3.144604] sun4i-drm display-engine: fb0: sun4i-drmdrmfb frame buffer device