Calibration of Linrad

[ON4KHG]

Dears,

I have installed Linrad 5.02 on my Raspi. All works well.

However, when I try to calibrate it, I type X, then C(alibrate) and I get B, C and D.

In the past there was a step before, the step A (Calibrate IQ phase and amplitude).

I don't see the A anymore. Could you please help me ?

Thanks in advance.

73,

Gaëtan, ON4KHG

[Leif]

Hi Gaëtan,

What is your hardware? Have you specified soundcard and
direct conversion?

73

Leif

> --
> There is an excellent Linrad User Guide by Gaetan, ON4KHG, at:
> http://w3sz.com/Linrad%20Installation%20&%20Configuration%20User%20Guide%20-%20V1-0.pdf
> ---
> You received this message because you are subscribed to the Google Groups "Linrad" group.
> To unsubscribe from this group and stop receiving emails from it, send an email to linrad+un...@googlegroups.com.
> To view this discussion visit https://groups.google.com/d/msgid/linrad/040f9fc9-e74c-4ac1-97d2-e32f078fbd6bn%40googlegroups.com.

[ON4KHG]

Hi Leif,

Nice to read from you again, it was long ago.

Thanks for your feedback.

Reading your question, I think I have the answer to my question : the option A applies for a soundcard.

Yes, I defined direct conversion.

My setup is a SDRPlay V3, so the B option (Total amplitude and phase) applies for the calibration, not the A one I guess.

Thanks again and have a nice day.

73,

Gaëtan, ON4KHG

You received this message because you are subscribed to a topic in the Google Groups "Linrad" group.
To unsubscribe from this topic, visit https://groups.google.com/d/topic/linrad/jbhDjv0NDxk/unsubscribe.
To unsubscribe from this group and all its topics, send an email to linrad+un...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/linrad/20260715173759.fb0d1d96bdce658c5d3ec65f%40sm5bsz.com.