Hi Anwesa,
It is likely the structure file incorrect.
1. try to redo it, only refine scale factors and unit cell. you should be able to get a certain fit Rw 50-70. it would say you can go ahead; Otherwise, you need to check structure file.
2. Normally I did is to do phase identification in a XRD software You may not get a good confident result because of nano, distortion, but at least you could get a few candidates, which matched with unit cell. start PDFgui with these files.
good luck.
Yu Wang
XRD Laboratory,
University of New South Wales,
Sydney, Australia
________________________________________
From:
diffpy...@googlegroups.com <
diffpy...@googlegroups.com> on behalf of Anwesa Samanta <
asam...@uic.edu>
Sent: Friday, August 19, 2022 6:12 AM
To: diffpy-users
Subject: [diffpy-users] about plotting the Gcalc
Hi all,
I am very new to using PDFgui, and whenever I am trying to fit a PDF data, the Gcalc in the plot comes out to be a flat red line as seen in the attached plot. Can anyone let me know about the plausible reasons behind this and anything I should keep in mind while preparing the phase file.
--
You received this message because you are subscribed to the Google Groups "diffpy-users" group.
To unsubscribe from this group and stop receiving emails from it, send an email to
diffpy-users...@googlegroups.com<mailto:
diffpy-users...@googlegroups.com>.
To view this discussion on the web visit
https://groups.google.com/d/msgid/diffpy-users/8e573a5a-ace4-495e-8910-dbb9271de46fn%40googlegroups.com<
https://groups.google.com/d/msgid/diffpy-users/8e573a5a-ace4-495e-8910-dbb9271de46fn%40googlegroups.com?utm_medium=email&utm_source=footer>.