You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to
Below is a brief list of application notes. These will range from ideas on improving the radar's operation, to troubleshooting common problems.
To
maximize the effectiveness of the Audio feedback system (listening to the beat
frequency), the ramp time should be set to a low value (1 or 2 ms). This shortens the unambiguous range and
emphasizes frequency with target range.
When
connecting over Bluetooth, SW1 (the push button switch located at the edge of the
RDK board between the light bar and USB port) must be pressed. This will flash all LEDs and allow the RDK to
communicate using Bluetooth.
When
sending commands to the RDK over a Bluetooth connection all commands must end
with the ‘$’ character. Example: to set the start frequency, send
sweep:freqstar$ to the RDK while using Bluetooth. If you are using the Quonset Microwave
Windows or Android App this can be disregarded since the applications handle this internally.