The group you are posting to is a Usenet group. Messages posted to this group will make your email address visible to anyone on the Internet.
Your reply message has not been sent.
Your post was successful
 |
From: Herón Ordóñez Guillén <hero...@gmail.com>
Date: Sun, 5 Aug 2012 13:14:27 -0500
Local: Sun, Aug 5 2012 2:14 pm
Subject: Re: [MakerBot] Re: model really stuck, Help (whimper)
I use a painter's spatula, and when the piece is delicate, I use it to raise a corner, then I take a piece of dental floss string and pass it through that space, pulling both ends until the piece is free.
El 05/08/2012, a las 12:44, MacGyver <bdwells2...@gmail.com> escribió:
> I've had extremely good luck with my new Cricut spatula. If it doesn't get far under the print I have a thin butter knife that will get the rest of the way under to pop prints off the platform.
> -- You must Sign in before you can post messages.
To post a message you must first join this group.
Please update your nickname on the subscription settings page before posting.
You do not have the permission required to post.
| |||||||||||||