My P4C800-E only enabled the back 4 by default, I have to turn on 5/6 for
the front panel, and 7/8 if i was to install the backplate they give me too.
This is with a Antec Sonata case too..
"Nero" <ne...@rome.it> wrote in message
news:SOJDb.1622$tQ6....@wards.force9.net...
You don't mention the Antec case model number. I've built a couple using the
SL 835. On those I had to hook up all 9 wires from the case to the mbd to
get the front port to work. The connector with the double wire I had to put
on pin 9 ( the unused ground).
mike in montana
R W Grn Blk blanked out
R W Grn Blk empty
Exactly as the backplate one for this board.
Since found that one of the two front ports work, other does not.
The data leads are (1)-D and (1)+D and the other set is (2)-D and (2)+D.
If you mix (1)-D with (2)+D, it won't work, so check that the wiring
looks something like this.
+5V (1)-D (1)+D GND (NC = No Connect)
+5V (2)-D (2)+D GND
Paul
After swapping the green wires, the front USB ports now work. Maybe you
have a similar problem.
Doug