Wood preservative for shed
shed...@lycos.co.uk
to paint a shed with? It's shiplap construction, and the
wood has a sort of green tinge to it, so I think it was
tanalised or similar before construction. Ideally the finish
would not be too dark, a sort of golden syrup colour
woulld be perfect. Preferably something that would last
a few years before I have to squeeze between the shed
and the fence again!
Thanks for any thoughts.
Danny
Frank Erskine
>Any thoughts on what would be the best preserving stuff
>to paint a shed with?
Creosote.
--
Frank Erskine
The Medway Handyman
> On Fri, 8 Feb 2008 13:57:03 -0800 (PST), shed...@lycos.co.uk wrote:
>
>> Any thoughts on what would be the best preserving stuff
>> to paint a shed with?
>
> Creosote.
Not allowed that anymore Frank. Effin Softy.
Creasote Substitute. No idea what it is, but I bet it isn't as good as real
creosote.
Ronseal/Cuprinol do some good stuff these days.
--
Dave - The Medway Handyman
www.medwayhandyman.co.uk
01634 717930
07850 597257
Andy Hall
<davi...@nospamblueyonder.co.uk> said:
> Frank Erskine wrote:
>> On Fri, 8 Feb 2008 13:57:03 -0800 (PST), shed...@lycos.co.uk wrote:
>>
>>> Any thoughts on what would be the best preserving stuff
>>> to paint a shed with?
>>
>> Creosote.
>
> Not allowed that anymore Frank. Effin Softy.
Now look, there's no need to be rude, like.
I would refer the honourable gentleman to the Viz website, wherein he
can learn the correct pronunciation for all points north of Sheerness.
>
> Creasote Substitute. No idea what it is, but I bet it isn't as good as real
> creosote.
>
> Ronseal/Cuprinol do some good stuff these days.
The key factor is to have good old down to earth high VoC solvent based
product. None of your wishy washy, water based rubbish.
On Tyneside they know this.
Si
>>> On Fri, 8 Feb 2008 13:57:03 -0800 (PST), shed...@lycos.co.uk wrote:
>>>
>>>> Any thoughts on what would be the best preserving stuff
>>>> to paint a shed with?
>
>product. None of your wishy washy, water based rubbish.
Would this be a good idea given that the Op is talking about having to
"squeeze between the shed and the fence" to apply it?
--
Si
DIY
Cuprinol springs to mind. Regarding restricted access, my shed is close to
the fence on two sides and it isn't possible to stand in the gap to apply
preservative. I use a hand-pumped pressure sprayer to overcome the access
problem.
Frank Erskine
<davi...@nospamblueyonder.co.uk> wrote:
>Frank Erskine wrote:
>> On Fri, 8 Feb 2008 13:57:03 -0800 (PST), shed...@lycos.co.uk wrote:
>>
>>> Any thoughts on what would be the best preserving stuff
>>> to paint a shed with?
>>
>> Creosote.
>
>Not allowed that anymore Frank. Effin Softy.
I can still buy it fairly easily. It's still 'permitted' for such as
telegraph poles, railway sleepers, et al.
--
Frank Erskine
Frank Erskine
wrote:
And Wearside.
--
Frank Erskine
ma...@atics.co.uk
Dear Danny
Is you address a coincidence? (smile).. on to the answer
If your shed (empahasis - can't use capitals any more!) ...is...
tanlalised then you do not need to preserve it. You need to find out
for sure. Look at the timber inside closely and see if it has the
green (or in later years possibly brown) tinge. To differentiate
between true water-borne vacuum impregnation and a later application
of a treatment fluid to get such a colour effect you will need to
"sacrifice" a small section of timber near the end grain of a piece
being investigated. go for a piece of treated end grain and cut a
longitudial sectioin out, say 1 mm thick , a 20 to 50 mm long and 5
to 10 mm wide such that you can see the whole of the cross section of
the end grain eithe tangentially or longitudinally. This will tell you
for sure (almost) if it has been treated under pressure as you will
see the treatment colour a long way up the end grain which would not
be the case with a brush application. If someone has done an immersion
treatment that may fool you but such a treatment is not likely with a
shed.
So assume you find it ...is... tanalised then all you need is a
decorative finish. Psuedo-creosote, (it is bound to be against COPR to
sell you real creosote - Elfin S again!) or much better Saddolins
medium build Water Repellant Preservative Stains.
If it has not been treated and you think you need to treat it - decide
why. Only consider treating areas at risk - sole plates - end grain
exposed etc etc and consider physical means first ( eg isolating sole
plates with a dpm). Were you a professional contractor - you would be
obliged to take this route under the Coshh regs. As an amateur you can
do virtually what you like provided you follow the instructions on the
tin.
I recommend (as posted by others) an OS based fungicide and
application on a hot summers day when a cold night is forecast. If you
can apply several coats - so much the better. Once the active
ingredient is in the timber proceed to protect with a WRPS as
described above.
Hope the shed is worth it!
Chris G
The Medway Handyman
> On 2008-02-08 23:51:09 +0000, "The Medway Handyman"
> <davi...@nospamblueyonder.co.uk> said:
>
>> Frank Erskine wrote:
>>> On Fri, 8 Feb 2008 13:57:03 -0800 (PST), shed...@lycos.co.uk
>>> wrote:
>>>> Any thoughts on what would be the best preserving stuff
>>>> to paint a shed with?
>>>
>>> Creosote.
>>
>> Not allowed that anymore Frank. Effin Softy.
>
> Now look, there's no need to be rude, like.
>
> I would refer the honourable gentleman to the Viz website, wherein he
> can learn the correct pronunciation for all points north of Sheerness.
I meant the Effin Softy at Werk Act you twit. I would never imply that a
Geordie was an effin softy - I like my front teeth too much!