Linux version 2.6.18.1-hrt (john@venus) (gcc version 3.4.4) #1 PREEMPT Tue Nov 7 18:00:05 CET 2006 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 00000000000a0000 (usable) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000000fff0000 (usable) BIOS-e820: 000000000fff0000 - 000000000fff3000 (ACPI NVS) BIOS-e820: 000000000fff3000 - 0000000010000000 (ACPI data) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) 255MB LOWMEM available. On node 0 totalpages: 65520 DMA zone: 4096 pages, LIFO batch:0 Normal zone: 61424 pages, LIFO batch:15 DMI 2.3 present. ACPI: RSDP (v000 VIA601 ) @ 0x000f6950 ACPI: RSDT (v001 VIA601 AWRDACPI 0x42302e31 AWRD 0x00000000) @ 0x0fff3000 ACPI: FADT (v001 VIA601 AWRDACPI 0x42302e31 AWRD 0x00000000) @ 0x0fff3040 ACPI: DSDT (v001 VIA601 AWRDACPI 0x00001000 MSFT 0x0100000c) @ 0x00000000 ACPI: PM-Timer IO Port: 0x4008 Allocating PCI resources starting at 20000000 (gap: 10000000:efff0000) Detected 1266.766 MHz processor. VSYSCALL: consistency checks...passed...mapping...done. VSYSCALL: fixmap virt addr: 0xffffd000 Built 1 zonelists. Total pages: 65520 Kernel command line: ro root=/dev/hda1 console=ttyS0,57600n8 console=tty0 panic=3 Local APIC disabled by BIOS -- you can enable it with "lapic" mapped APIC to ffffc000 (01201000) Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Initializing CPU#0 Clock event device pit configured with caps set: 07 PID hash table entries: 1024 (order: 10, 4096 bytes) Console: colour dummy device 80x25 Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) Memory: 256840k/262080k available (1626k kernel code, 4752k reserved, 532k data, 160k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay using timer specific routine.. 2535.90 BogoMIPS (lpj=5071805) Mount-cache hash table entries: 512 CPU: After generic identify, caps: 0383f9ff 00000000 00000000 00000000 00000000 00000000 00000000 CPU: After vendor identify, caps: 0383f9ff 00000000 00000000 00000000 00000000 00000000 00000000 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 512K CPU: After all inits, caps: 0383f9ff 00000000 00000000 00000040 00000000 00000000 00000000 Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. Compat vDSO mapped to ffffe000. CPU: Intel(R) Pentium(R) III CPU - S 1266MHz stepping 04 Checking 'hlt' instruction... OK. ACPI: Core revision 20060707 ACPI: setting ELCR to 0200 (from 1e20) NET: Registered protocol family 16 ACPI: bus type pci registered PCI: PCI BIOS revision 2.10 entry at 0xfb210, last bus=2 PCI: Using configuration type 1 Setting up standard PCI resources ACPI: Interpreter enabled ACPI: Using PIC for interrupt routing ACPI: PCI Root Bridge [PCI0] (0000:00) PCI: Probing PCI hardware (bus 00) ACPI: Assume root bridge [\_SB_.PCI0] bus is 0 PCI quirk: region 6000-607f claimed by vt82c686 HW-mon PCI quirk: region 5000-500f claimed by vt82c686 SMB PCI: Firmware left 0000:00:08.0 e100 interrupts enabled, disabling PCI: Firmware left 0000:00:09.0 e100 interrupts enabled, disabling PCI: Firmware left 0000:00:0a.0 e100 interrupts enabled, disabling ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT] ACPI: PCI Interrupt Link [LNKA] (IRQs 1 3 4 5 6 7 10 11 *12 14 15) ACPI: PCI Interrupt Link [LNKB] (IRQs 1 3 4 5 6 7 *10 11 12 14 15) ACPI: PCI Interrupt Link [LNKC] (IRQs 1 3 4 5 6 7 10 *11 12 14 15) ACPI: PCI Interrupt Link [LNKD] (IRQs 1 3 4 *5 6 7 10 11 12 14 15) Linux Plug and Play Support v0.97 (c) Adam Belay pnp: PnP ACPI init pnp: PnP ACPI: found 13 devices PCI: Using ACPI for IRQ routing PCI: If a device doesn't work, try "pci=routeirq". If it helps, post a report PCI: Bridge: 0000:00:01.0 IO window: disabled. MEM window: disabled. PREFETCH window: disabled. PCI: Bridge: 0000:00:0d.0 IO window: disabled. MEM window: disabled. PREFETCH window: disabled. PCI: Setting latency timer of device 0000:00:01.0 to 64 NET: Registered protocol family 2 IP route cache hash table entries: 2048 (order: 1, 8192 bytes) TCP established hash table entries: 8192 (order: 3, 32768 bytes) TCP bind hash table entries: 4096 (order: 2, 16384 bytes) TCP: Hash tables configured (established 8192 bind 4096) TCP reno registered Machine check exception polling timer started. IA-32 Microcode Update Driver: v1.14a io scheduler noop registered io scheduler cfq registered (default) PCI: Disabling Via external APIC routing ACPI: Power Button (FF) [PWRF] ACPI: Power Button (CM) [PWRB] ACPI: CPU0 (power states: C1[C1] C2[C2]) ACPI: Processor [CPU0] (supports 2 throttling states) Non-volatile memory driver v1.2 Linux agpgart interface v0.101 (c) Dave Jones agpgart: Detected VIA Apollo Pro 133 chipset agpgart: AGP aperture is 64M @ 0xe0000000 Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A serial8250: ttyS2 at I/O 0x3e8 (irq = 4) is a 16550A 00:08: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A 00:09: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A 00:0c: ttyS2 at I/O 0x3e8 (irq = 4) is a 16550A loop: loaded (max 8 devices) Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: IDE controller at PCI slot 0000:00:07.1 PCI: VIA IRQ fixup for 0000:00:07.1, from 255 to 0 VP_IDE: chipset revision 6 VP_IDE: not 100% native mode: will probe irqs later VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci0000:00:07.1 ide0: BM-DMA at 0xd000-0xd007, BIOS settings: hda:pio, hdb:pio ide1: BM-DMA at 0xd008-0xd00f, BIOS settings: hdc:pio, hdd:pio Probing IDE interface ide0... hda: PQI IDE DiskOnModule, ATA DISK drive hda: set_drive_speed_status: status=0x51 { DriveReady SeekComplete Error } hda: set_drive_speed_status: error=0x04 { DriveStatusError } hda: set_drive_speed_status: status=0x51 { DriveReady SeekComplete Error } hda: set_drive_speed_status: error=0x04 { DriveStatusError } ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... Probing IDE interface ide1... hda: max request size: 128KiB hda: 256000 sectors (131 MB) w/1KiB Cache, CHS=500/16/32 hda: hda1 hda2 hda3 hda4 PNP: PS/2 Controller [PNP0303:PS2K] at 0x60,0x64 irq 1 PNP: PS/2 controller doesn't have AUX irq; using default 12 serio: i8042 AUX port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 mice: PS/2 mouse device common for all mice oprofile: using timer interrupt. netem: version 1.2 TCP bic registered NET: Registered protocol family 1 NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller Using IPI Shortcut mode VFS: Mounted root (ext2 filesystem) readonly. Time: tsc clocksource has been installed. Freeing unused kernel memory: 160k freed Time: acpi_pm clocksource has been installed. process `syslogd' is using obsolete setsockopt SO_BSDCOMPAT