EZDAC Builders

See the welcome message above. The new forum is hosted by informe.com: http://ezdiyaudio.informe.com

You can tell it's 4.45am here in the UK - look at all my spelling mistakes! Prives? :-D

Much prefer the layout of the alternative, but it seems rather slow. Might be a one-off, but I was

Hi! I just measure the output voltage of PCM1794 ezDAC will the oscilloscope, R27,28,33,24 are 1.5K

Yes, thought I'd post the Farnell link just incase:-) I actually fitted one of thoseC&D ones

I've changed the BOM :) -evan On May 29, 8:50 pm, claudio...@hotmail.com wrote: > Thank to you

I forgot to mention I recently tried a Burson low jitter clock with the Ezdac replacing the PFM Flea,

That's helpful info, cyclebrain. Thanks! What transformer did you use for your EZDUAL/EZDAC kit?

Cool! Thanks! Ted On May 15, 6:07 pm, "Evan Zamir" <zamir.e...@gmail.com> wrote: >

Hi guys, I got my boards a couple weeks ago, followed by most of the parts - there are a few

Leo, keep us posted. It's good to know that the same DAC can be improved so much just with better

Ok, I will wait for my EZDAC to arrive better visualize the way out. Thanks. Claudio On 12 Apr, 06:48

So, prompted by John's efforts with the DAC, I thought I would post a circuit simulation I did

No, I have not done any previous measurements on a DAC. I just wanted to be sure that this one wasn

Tens of ohms is correct. I have been thinking about adding a 100 ohm resistor in series with the

I used a Potter Brumfield DPDT 24VDC relay and powered it from the negative EZ-PSU supply since it

Hey, folks. I ordered some new boards this week, and immediately noticed that they looked very shiny.

Thanks, Leo! I hope it helps, and I look forward to seeing (and hearing about) your progress. On Feb

If you have any questions about the EZDAC, from the design to building it to choosing parts, please