** LOADER ** ** MARVELL BOARD: DB-88F5182-DDR2 LE U-Boot 1.1.1 (Feb 20 2009 - 16:05:55) Marvell version: 2.2.2.Chopper.04 U-Boot code: 00200000 -> 0026FFF0 BSS: -> 0027BC90 Soc: 88F5182 A2 (DDR2) CPU running @ 400Mhz SysClock = 200Mhz , TClock = 166Mhz DRAM CS[0] base 0x00000000 size 64MB DRAM Total size 64MB [16384kB@ff000000] Flash: 16 MB Addresses 4M - 0M are saved for the U-Boot usage. Mem malloc Initialization (4M - 3M): Done CPU : ARM926 (Rev 0) 88F5182 A2 streaming disabled USB 0: host mode USB 1: host mode Net: egiga0 [PRIME] Hit any key to stop autoboot: 0 ## Booting image at ff040000 ... Image Name: Alt-F-0.1RC2, kernel 2.6.35.14 Created: 2012-02-21 18:34:49 UTC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 1567060 Bytes = 1.5 MB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... OK OK ## Loading Ramdisk Image at ff1c0000 ... Image Name: Alt-F-0.1RC2, initramfs Created: 2012-02-21 18:34:50 UTC Image Type: ARM Linux RAMDisk Image (uncompressed) Data Size: 6389887 Bytes = 6.1 MB Load Address: 00800000 Entry Point: 00800000 Verifying Checksum ... OK Starting kernel ... Uncompressing Linux... done, booting the kernel. Linux version 2.6.35.14 (jcard@silver) (gcc version 4.3.3 (GCC) ) #1 Tue Feb 21 15:39:06 WET 2012 CPU: Feroceon [41069260] revision 0 (ARMv5TEJ), cr=a0053177 CPU: VIVT data cache, VIVT instruction cache Machine: D-Link DNS-323 Clearing invalid memory bank 0KB@0x00000000 Clearing invalid memory bank 0KB@0x00000000 Clearing invalid memory bank 0KB@0x00000000 Ignoring unrecognised tag 0x00000000 Ignoring unrecognised tag 0x00000000 Ignoring unrecognised tag 0x00000000 Ignoring unrecognised tag 0x41000403 Memory policy: ECC disabled, Data cache writeback Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256 Kernel command line: root=/dev/ram console=ttyS0,115200 :::DB88FXX81:egiga0:none PID hash table entries: 256 (order: -2, 1024 bytes) Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Memory: 64MB = 64MB total Memory: 55596k/55596k available, 9940k reserved, 0K highmem Virtual kernel memory layout: vector : 0xffff0000 - 0xffff1000 ( 4 kB) fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB) DMA : 0xffc00000 - 0xffe00000 ( 2 MB) vmalloc : 0xc4800000 - 0xfd800000 ( 912 MB) lowmem : 0xc0000000 - 0xc4000000 ( 64 MB) modules : 0xbf000000 - 0xc0000000 ( 16 MB) .init : 0xc0008000 - 0xc0026000 ( 120 kB) .text : 0xc0026000 - 0xc02d2000 (2736 kB) .data : 0xc02ea000 - 0xc02ffb80 ( 87 kB) NR_IRQS:64 Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200) pid_max: default: 4096 minimum: 301 Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok NET: Registered protocol family 16 Orion ID: MV88F5182-A2. TCLK=166666667. DNS-323: Identified HW revision C1 DNS-323: Failed to read MAC address bio: create slab at 0 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb Switching to clocksource orion_clocksource NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 2048 (order: 2, 16384 bytes) TCP bind hash table entries: 2048 (order: 1, 8192 bytes) TCP: Hash tables configured (established 2048 bind 2048) TCP reno registered NET: Registered protocol family 1 Unpacking initramfs... Freeing initrd memory: 6240K squashfs: version 4.0 (2009/01/31) Phillip Lougher aufs 2-standalone.tree-35-20100809 msgmni has been set to 120 io scheduler noop registered io scheduler deadline registered io scheduler cfq registered (default) Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0xf1012000 (irq = 3) is a 16550A console [ttyS0] enabled loop: module loaded sata_mv sata_mv.0: version 1.28 sata_mv sata_mv.0: slots 32 ports 2 scsi0 : sata_mv scsi1 : sata_mv ata1: SATA max UDMA/133 irq 29 ata2: SATA max UDMA/133 irq 29 physmap platform flash device: 00800000 at f4000000 physmap-flash.0: Found 1 x16 devices at 0x0 in 8-bit bank NOR chip too large to fit in mapping. Attempting to cope... Amd/Fujitsu Extended Query Table at 0x0040 number of CFI chips: 1 Reducing visibility of 16384KiB chip to 8192KiB cmdlinepart partition parsing not available RedBoot partition parsing not available Using physmap partition information Creating 5 MTD partitions on "physmap-flash.0": 0x000000000000-0x000000010000 : "MTD1" mtd: partition "MTD1" doesn't end on an erase block -- force read-only 0x000000010000-0x000000020000 : "MTD2" mtd: partition "MTD2" doesn't start on an erase block boundary -- force read-only 0x000000020000-0x0000001a0000 : "Linux Kernel" 0x0000001a0000-0x0000007d0000 : "File System" mtd: partition "File System" doesn't end on an erase block -- force read-only 0x0000007d0000-0x000000800000 : "u-boot" mtd: partition "u-boot" doesn't start on an erase block boundary -- force read-only MV-643xx 10/100/1000 ethernet driver version 1.4 mv643xx_eth smi: probed net eth0: port 0 with MAC address 00:00:00:00:51:81 ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver orion-ehci orion-ehci.0: Marvell Orion EHCI orion-ehci orion-ehci.0: new USB bus registered, assigned bus number 1 orion-ehci orion-ehci.0: irq 17, io mem 0xf1050000 orion-ehci orion-ehci.0: USB 2.0 started, EHCI 1.00 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. input: gpio-keys as /class/input/input0 i2c /dev entries driver rtc-m41t80 0-0068: chip found, driver version 0.05 rtc-m41t80 0-0068: rtc core: registered m41t80 as rtc0 lm75 0-0048: hwmon0: sensor 'lm75' md: linear personality registered for level -1 md: raid1 personality registered for level 1 usbcore: registered new interface driver usbhid usbhid: USB HID core driver TCP cubic registered NET: Registered protocol family 17 rtc-m41t80 0-0068: setting system clock to 2013-02-07 17:31:42 UTC (1360258302) ata1: SATA link down (SStatus 0 SControl 300) ata2: SATA link down (SStatus 0 SControl 300) Freeing init memory: 120K pre-init started, pid=1 pre-init: aufs pre-init: squashfs aufs test_add:253:mount[53]: uid/gid/perm /tmproot/rootsq 0/0/0777, 0/0/0755 init started: BusyBox v1.19.3 (2012-02-21 15:37:53 WET) root: fsck 1.41.14 (22-Dec-2010) fsck.minix: BusyBox v1.19.3 (2012-02-21 15:37:53 WET) /dev/mtdblock0 is clean, check is skipped attempt to access beyond end of device mtdblock0: rw=0, want=130, limit=128 Buffer I/O error on device mtdblock0, logical block 64 attempt to access beyond end of device mtdblock0: rw=0, want=132, limit=128 Buffer I/O error on device mtdblock0, logical block 65 attempt to access beyond end of device mtdblock0: rw=0, want=130, limit=128 Buffer I/O error on device mtdblock0, logical block 64 attempt to access beyond end of device mtdblock0: rw=0, want=132, limit=128 Buffer I/O error on device mtdblock0, logical block 65 attempt to access beyond end of device mtdblock0: rw=0, want=130, limit=128 Buffer I/O error on device mtdblock0, logical block 64 attempt to access beyond end of device mtdblock0: rw=0, want=132, limit=128 Buffer I/O error on device mtdblock0, logical block 65 attempt to access beyond end of device mtdblock0: rw=0, want=130, limit=128 Buffer I/O error on device mtdblock0, logical block 64 attempt to access beyond end of device mtdblock0: rw=0, want=132, limit=128 Buffer I/O error on device mtdblock0, logical block 65 tar: short read attempt to access beyond end of device mtdblock0: rw=0, want=130, limit=128 Buffer I/O error on device mtdblock0, logical block 64 attempt to access beyond end of device mtdblock0: rw=0, want=132, limit=128 Buffer I/O error on device mtdblock0, logical block 65 attempt to access beyond end of device mtdblock0: rw=0, want=130, limit=128 attempt to access beyond end of device mtdblock0: rw=0, want=132, limit=128 attempt to access beyond end of device mtdblock0: rw=0, want=130, limit=128 attempt to access beyond end of device mtdblock0: rw=0, want=132, limit=128 tar: short read cat: can't open '/tmp/xfstab': No such file or directory rm: can't remove '/tmp/xfstab': No such file or directory mv: can't rename '/tmp/ucron': No such file or directory root: FIXME: Waiting 3 sec for kernel enumeration to finish... root: FIXME: stop waiting. root: IP from flash-defaults ifup: ignoring unknown interface eth0 root: Starting syslogd: OK. Starting klogd: OK. root: Starting urandom: OK. root: Starting sysctrl: OK. usbcore: registered new interface driver usblp root: dropbear: generating rsa key... dropbear: generating dsa key... Starting inetd: OK. root: Starting nmbd: OK. Starting smbd: OK. root: Starting user: OK. / # ifconfig lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) / #