mouselook in Q1???

[Grot]

Can someone please tell me how to mouselook in Quake 1.

I binded a key to do it but when I release that key it stops mouselooking.

Is there a special set of comands etc. that I have to set up in config?
If so, any info would be great.

cya

Grot

[Pete Hind]

Hmmmm.... don't bind a key to +mlook if you want to use it all the time. Just
add the line +mlook to your autoexec.cfg.
Alternatively, I think you can switch it on permanently in-game.. which writes
to your config.cfg.

Cheers
Setanta

Grot wrote:

--
"No dammit, it's not OK. Where's the [NOT OK] button?"
(Micro$oft General Protection Fault No. !@#$%*&)

Email: pmh...@zipworld.com.au (Remove "Spamblock" to reply).
ph...@carlo-high.nsw.edu.au (work)
http://www.zipworld.com.au/~pmhind

[LoneGunman]

Steve is correct unless you just type +mlook in the console or put the line
in your config. Then mouse look will stay on all the time, until you
type -mlook.

LoneGunman

Grot wrote in message <7lkjqk$p89$1...@the-fly.zip.com.au>...

[Repo]

type at the console *+mlook*

[Eben Bolter]

type +mlook

[Pinko Commie]

AAAAAAAAAAAAAARGH!!!!!!!!!1

I never knew you could have mouselook permantly on in Quake by using
+mouselook. I've always had to configure mouselook as [END], remove the
keycap and then jam a biro into it to keep the switch pressed. Either that
or use [left-shift] and use a packet of rizla's/a screw/a spoon/ a coin/ a
bit of carpet/ anything that comes to hand etc etc to jam the key down.

If only I'd known!

DOH!

[InfectoR {Shane White}]

LOL, man you nearly had me there :)

Pinko Commie wrote in message <7lqhdu$ofa$1...@apple.news.easynet.net>...

[Bertoni]

Just type +mlook
in the consoile when starting...