X-Machines 3D Printers

Hi Jon, Were you able to successfully upgrade the board in your Lorei? And is it straightforward or

Hey Dan, It sounds to me like its not using your z offset settings. I haven't used my printer for

Also, can you copy/paste the G-Code text? when I'm implementing it in my "new printer"

It's been non-stop headaches for me. Big issue is I can't seem to get the PLA to stick to the

I need to get rid of my Duo to make room for my CR-6 Max. I've barely used it since I got my

Hi there The time has come to say 'goodbye' to my Lorei Duo .... It was fun since i have it

Ah Cool, I also have the Duo and I added the heating bed right before they close. I had to reflash

If there isn't one setup, one of you senior advanced users should definitely set one up! Maybe i

I got it plugged in to power and tested with the AutoLevel and it seems functional. The nozzles for

Honestly, this is not the machine to learn on in my opinion. There isnt a support community for this

If the head comes down and the sensor behind the head is not over the metal bed, then the sensor will

I replaced mine with openbuild ones a while back, no problem replacing the but I had to readjust the

My xMachines Lorei Duo is still my main printer and I had no issues at all despite a fans on one

Sandro, What would you recommend for a replacement controller? Both stepper motor drivers for the

I am going to print this and attempt to modify my machine. Do you happen to have detailed photos or

I had issues with this section initially as well. Reflecting. I would say the config files are in the

hi Jesse i turned ON my lorei with all wire in place no led ON except 1 steady led(d3) in the center

Here it is https://groups.google.com/d/msg/x-machines-3d-printers/sYxmFnQlK1o/_-oHlZZxAQAJ

Ugh. I totally spaced out on doing a newer walk-through. I should probably also post/push my changes

Global 3D Labs the best and safest to buy 3D printers in India. We manufacture a wide range of best-

JST-XH if I'm not mistaken. 2.54mm pitch.

I would also suggest that you get an external relay and drive heated bed directly from the power

It is indeed 24v.

How much are ya asking for? When was the last time you used it? And does it still work?

My motherboard is hs can you indicate another motherboard for replace xmachines thanks

I have been sidelined by the flu for a few days but hope to start on the posts to thingiverse this

Lorei Design Changes: Heated Bed Redesign spring mounted 4 point independent adjustment new glass

Lorei Design Changes: Y Axis stabilizer/adjuster printer unstable when not on perfectly level surface

Lorei Design Changes: X carriage redesign new cooling fans and fan vents x axis limit switch position