Traktor S2 Mk2 Driver

0 views

Skip to first unread message

Darth Gupta

unread,

Aug 3, 2024, 4:41:17 PM8/3/24

to whittwochalling

The DN-X1600 used to work fine with Traktor Pro 2 soft but suddenly, probably because of Traktor update, I could not use timecode anymore. So I renewed Traktor once more to v 2.11 and found out that the 32 bit version is not available anymore. So I set it up with Asio4All as is guided. I have the sound on all channels as expected but Scratch is disabled, is there a solution?

1.) Can you with any ASIO driver switch the traktor decks to internal playback and hear the tracks?2.) Is the mixer set for routing phono inputs into the interface (refer to user manual) in DVS mode?3.) Post screenshots of each ASIO driver settings (mixers needs to be shown as connected etc)4.) Why are you running the sampling rate at 96khz?

I understand that I need to enter reduced security mode for the silicon M1 chip to allow the installation of drivers for Traktor kontrol x1. My question is how do I remain in reduced security and allow access to downloads where the required driver is located?

You install the drivers while the Mac is in reduced security. When you are done installing I would also test to see if Traktor kontrol x1 works. Then boot to Recovery and re-establish full security and then boot normally and use the Mac normally.

I want to use ubuntu budgie remix 16.10, I'm dj and I have a MIDI controller that controls a sofware, called traktor pro. I use the controller in windows 7 ulltimate without problem, but I want to use it in ubuntu.