GE front load. Seating the drum

43 views
Skip to first unread message

Mark Crandall

unread,
Aug 12, 2022, 4:12:50 PM8/12/22
to Washer Repair
image0.jpegI am trying to figure out if I have seated the drum deep enough in the bearings.  the shaft does not appear to be flush with the outer bearing; however, I cannot get it go any further.  I cannot see if the seal is mated since there is no way to view the inside.   Thoughts? 
Reply all
Reply to author
Forward
Message has been deleted
0 new messages