Wandboard CAN Interface

126 views
Skip to first unread message

Aravind Sivaram

unread,
Feb 6, 2015, 4:09:15 AM2/6/15
to wand...@googlegroups.com
Hi,
   I am facing an issue  while interfacing CAN with WANDBOARD SOLO.  
 The Test points given on the *wandboard* namely CAN_1p, CAN_1n, CAN_2p, CAN_2n are not connected to the IMx 6 processor.  
  
   PIN  EDM-IMX6  WAND

   CAN2p      TP125       TP112
   CAN2n      TP126    TP113
   CAN1p      TP38    TP114
   CAN1n      TP37    TP115

Any Clues??

Nilesh Kokane

unread,
Feb 9, 2015, 12:11:46 AM2/9/15
to wand...@googlegroups.com
Hi, all,

Even I ran in the same problem as Arvind is. Can anyone please help.

Perhaps, I just had a look at the console logs from wandboard and I can see *Flexcan* enabled on Yocto 1.6.1 daisy.But the connections on the board are puzzling me out. Please help.
Arvind, did you find any  solution? 

--
Nilesh Kokane

Nilesh Kokane

unread,
Mar 7, 2015, 12:50:09 AM3/7/15
to wand...@googlegroups.com


On Friday, February 6, 2015 at 2:39:15 PM UTC+5:30, Aravind Sivaram wrote:
Can anyone please reply on this..? 

Nilesh Kokane

unread,
Mar 7, 2015, 1:28:14 AM3/7/15
to wand...@googlegroups.com
Reply all
Reply to author
Forward
0 new messages