TRL waveguide calibration using three shim

[Tuomas Haitto]

Hello,

If I want perform TRL waveguide calibration using three offset shim (1/4, 1/8 and 3/8), which calibration type I should choose from VNA-Tools calibration config?

Does it goes right if I just choose TRL and add two more "Line 1,2" where I'm telling my

shim definitions

-Tuomas 

[Michael Wollensack METAS]

Hi Tuomas,

take a look at example called 06_TRL_Example_3.5mm(f-m).

Go for an optimization calibration and use a TRL calibration with one shim as start values.

Regards

Michael