General Electric P7 Wall Oven Manual

[Annemie]

Areyou looking for information on using the GE JKP27 electric wall oven? This user manual contains important warranty, safety, and product feature information. View the user manual below for more details. Want a copy for yourself? Download or print a free copy of the user manual below.

FOR YOUR SAFETY:WARNING

Before beginning the installation, switch power off at the service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

Be sure the oven is securely installed in a cabinet that is firmly attached to the house structure. Weight on the oven door could cause the oven to tip and result in injury. Never allow anyone to climb, sit, stand, or hang on the oven door.

Make sure the wall coverings, counters, and cabinets around the oven can withstand the heat (up to 200F [93.3C]) generated by the oven.

DESIGN INFORMATION

SINGLE OVEN INSTALLATIONS

The single oven may be installed in a cabinet alone or above a warming drawer. The single oven may also be installed side by side, below a countertop, or below specified cooktops. See the label on top of the oven for approved models.

DOUBLE AND COMBINATION OVEN INSTALLATIONS

A double or combination oven may be installed in a cabinet alone or above a warming drawer. See the label on top of the oven for approved models.IMPORTANT: Always refer to individual installation instructions packed with each product for specific requirements.

ELECTRICAL REQUIREMENTS (CONT.)

This appliance must be supplied with the proper voltage and frequency and connected to an individual, properly grounded branch circuit, protected by a circuit breaker or fuse. See the rating plate located on the oven frame to determine the rating of the product.Use the chart below to determine the minimum recommended dedicated circuit protection:

MAKE ELECTRICAL CONNECTIONSWARNING

Switch power off at the service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

Place oven on table or platform even with the cutout opening. For a single oven, the platform must support 220 lbs. (99 kg); for a double or combination oven, the platform must support 400 lbs.

(181 kg). Connect the flexible conduit to the electrical junction box as shown below*. Position the conduit in such a manner that it will lie behind the unit in a natural loop when the oven is installed**. You will need to purchase an appropriate strain-relief clamp to complete the connection of the conduit to the junction box.

Drill through the mounting holes (top and bottom) of the side trim for the #8 mounting screws provided. Secure the oven cabinet with the screws provided.Some models have custom handles. Please follow the instructions with the handles for proper installation.

With oven installed, attach the bottom trim through its mounting holes in the front vertical brace using two trim screws provided. The bottom trim lip must be placed under the flange of the bottom air duct.IMPORTANT: If this unit is ever removed from the cabinet or the oven is ever pulled out for service, the bottom trim must be removed first or damage to the trim will occur.

@manualsplus YouTubeManuals+,Privacy PolicyThis website is an independent publication and is neither affiliated with nor endorsed by any of the trademark owners. The "Bluetooth" word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. The "Wi-Fi" word mark and logos are registered trademarks owned by the Wi-Fi Alliance. Any use of these marks on this website does not imply any affiliation with or endorsement.

3a8082e126