maximum inner dimensions of laser cutter

[Daniel Hall]

Hello VHS;

I have another question about the laser cutter dimentions. What is the largest piece of material that can be fit flat inside the laser enslosure? I have a piece of acrilic

[Kevin]

I hear there are doors on the side that open to allow material larger than the cutting area to be used, thought it would likely be somewhat hobbled by the size of the lasercutter room

[Loial Otter]

I've found there's about 20cm on each side and about the same on the back. 4' material does fit inside the machine so I suggest, if getting full sheets of 8'x4', cutting into three equal pieces or so.

Remember you can either use the sides or back not both. Only use the back if there is no other option as that is where the tube is and wouldn't want anything jarring it's holders.