07 Transit Connect EML

[T i m]

Hi all,

Daughter just asked me to look at her van as the EML came on last
night. I plugged in my laptop / Forscan and found some fault codes and
cleared most, but whilst the EML is now out, one fault still persists
(the top one, pre clearing them all but left the cleared ones in in
case there is some correlation etc):

===PCM DTC P0380-68===
Code: P0380 - Glowplug control circuit

Additional Fault Symptom:
- Invalid Signal

Status:
- DTC Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Powertrain Control Module

Diagnostic Trouble Code details

Glow Plug Circuit

Short circuit

Open circuit.

This DTC may be caused by :

Possible causes are:

Relay control circuit

Glow plug relay

Malfunctioning EDCM

===END PCM DTC P0380-68===

===PCM DTC P0490-E1===
Code: P0490 - Exhaust Gas Recirculation Control Circuit High

Additional Fault Symptom:
- Signal is Above Maximum Threshold

Status:
- DTC Present at Time of Request
- Malfunction Indicator Lamp is On for this DTC

Module: Powertrain Control Module

Diagnostic Trouble Code details

Exhaust Gas Recirculation Control Circuit High

This DTC is set when the following condition occurs.

The EGRV position sensor value is consistently higher than the desired
set value.

This DTC may be caused by :

EGR valve short circuit to battery positive.

Exhaust Gas Recirculation Valve

For further diagnostic information refer to the appropriate section of
eTIS.

===END PCM DTC P0490-E1===

===ABS DTC None===
Successful DTC reading, no error codes found

Module: Antilock braking system

===END ABS DTC None===

===IC DTC P0000-66===
Code: P0000 - Unrecognized fault code

Additional Fault Symptom:
- Signal is Below Minimum Threshold

Status:
- DTC Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Instrument Cluster

Diagnostic Trouble Code details

While using DLM, check for the following possible faults:

Check for an intermittent electrical fault.

Lightly wiggle on the component and connector while monitoring
signals. Take care not to bend or twist any connector as this will
cause damage.

Continue to monitor signals and look for sudden changes in values.

Starting at the component, wiggle and pull each component wire.

Wiggle and pull small isolated sections of the wiring harness.

Inspect connectors for signs of damage, water ingress, corrosion, etc.

===END IC DTC P0000-66===

===IC DTC C1210-0A===
Code: C1210 - Right Front Outlet Valve Coil Circuit Failure

Additional Fault Symptom:
- Signal is Below Minimum Threshold

Module: Instrument Cluster

Diagnostic Trouble Code details

Right Front Outlet Valve Coil Circuit Failure

===END IC DTC C1210-0A===

===CSM DTC None===
Successful DTC reading, no error codes found

Module: Security module

===END CSM DTC None===

===ECS DTC None===
Successful DTC reading, no error codes found

Module: Electronic Crash Sensor

===END ECS DTC None===

Any thoughts please guys?

Cheers, T i m