basin waste sizes....
Jim K
but what's the diameter of the actual hole in the ceramic to take such
a "normal" size waste?
(I've been offered a nice looking basin but told it takes a 1 3/4"
waste fitting ?? Hoping they;ve measured the "hole" and mis-
assumed...unless someone knows better?)
ta
Jim K
Tabby
The usual waste sizes are 1.25", 1.5", 2", aka 32mm, 40mm, 50mm. The
sink holes are rather larger for each - just go to the plumbing shop
with the measurements.
NT
Baz
"Jim K" <jk98...@gmail.com> wrote in message
news:a3bdccdb-b700-417e...@c20g2000yqj.googlegroups.com...
The OD of 1 1/4" BSP is 1.65".
So if "They" have just measured the Hole and it is 1 3/4" then 1 1/4" will
fit.
Baz
Roger Mills
It would be unusual for a basin to have anything bigger than a 1 1/4"
waste. However, to the best of my knowledge, a 1 1/4" waste will have a
1 1/4" BSP thread - whose OD is about 1.65" - and there's usually plenty
of clearance, so a 1.75" hole sounds about right.
--
Cheers,
Roger
____________
Please reply to Newsgroup. Whilst email address is valid, it is seldom
checked.