In article <naalu7$ust$
1...@dont-email.me>,
d...@auk.kent.ac.uk (D.M.Chapman) writes:
>
> Hi all,
>
> Looking to kit out an unfurnished house in the near future - tempted to find
> stuff on Gumtree or similar but a fridge freezer seems a bit much to get in
> the back of my mondeo?
>
> Are they generally ok if laid down these days, as long as they are left to
> stand for a while? Was that ever really a problem or just an urban legend?
I laid a freezer on its side to replace the insulation on the bottom.
I left it standing upright for many hours afterwards before turning on,
but it didn't survive - motor burned out, which is the failure mode after
doing this.
Afterwards (too late), I got suggestions from Hotpoint on what to do if
a freezer has been tipped significantly off-vertical. Turn it on only
for 30 seconds or so every 10 mins over a period, which may get the
refrigerant/lubricant back to where they should be. My other thought
after the event was to make sure the pipework from the compressor to
the condenser (hot rear element) gets hot, as the failure results in
the heat not being removed from the compressor motor so it overheats
internally. The compressor and motor are cooled by the refrigetant
taking the heat away to the condenser. You might also run it on a
power meter to check the power consumption is not excessive (locked
rotor), or on a low value fuse (although that's not long-term viable
as locked rotor is expected from time-to-time, which will cause
power consumption of more than 3kW for a few seconds, and will blow
a low valued fuse).
--
Andrew Gabriel
[email address is not usable -- followup in the newsgroup]