MPLAB ICD2 programmer problem
1,965 views
Skip to first unread message
zuhaib umar Khanzada
Mar 31, 2011, 3:28:05 AM3/31/11
to uavde...@googlegroups.com
Hi all ,
I am getting an error message given below while connecting
MPLAB ICD2, MPLABCdsPICStdEval_v3_23. MPLAB_IDE_8_46.
This message is persistent although I had tried every possible remedy given in common error , mistakes manual so many times.
Even I re installed All the softwares on an other PC,but getting the same error.
error message is
ICD0019: Communications: Failed to open port (USB): (Windows::GetLastError() = 0x2, 'The system cannot find the file specifi
')
ICD0021: Unable to connect with MPLAB ICD 2 (USB)
MPLAB ICD 2 ready for next operation
Connecting to MPLAB ICD 2
ICD0019: Communications: Failed to open port (USB): (Windows::GetLastError() = 0x2, 'The system cannot find the file specified.
')
ICD0021: Unable to connect with MPLAB ICD 2 (USB)
MPLAB ICD 2 ready for next operation
Murali- VU3MUV
Apr 1, 2011, 1:29:35 PM4/1/11
to uavde...@googlegroups.com
Hi Umar,
I had this experience recently . The setup was working successfully almost a year ago, but few days back when plugged every thing back on the same compute , i got the same msg/issue ( unable to find the USB driver..).
Cure was to read the " PICProgrammingGettingStarted.pdf " Care fully once again and start fresh. I uninstalled the older ver and downloaded the MP lab 8.66 fresh . Do not plug the ICD 2 at this time. Just install the newer MP lab and complier as per the said document. Once done plug in the ICD 2 , when it asks for driver , point it to folder driver folder under ICD2 under MPLAB IDE.
the path if default installation is used will be some thing like this
.../program files/Microchip/MPLAB IDE/ICD2/Drivers.
If you are using USB to power up ICD2 then you don't have to worry. I was searching for drivers every were else and then realized it is MPLABs baby. Note , some low quality USB cables have issues , so try changeing it too. You don't need to plug UDB to ICD2 for MPLab to resolve this issue.
cheers
Morli
I had this experience recently . The setup was working successfully almost a year ago, but few days back when plugged every thing back on the same compute , i got the same msg/issue ( unable to find the USB driver..).
Cure was to read the " PICProgrammingGettingStarted.pdf " Care fully once again and start fresh. I uninstalled the older ver and downloaded the MP lab 8.66 fresh . Do not plug the ICD 2 at this time. Just install the newer MP lab and complier as per the said document. Once done plug in the ICD 2 , when it asks for driver , point it to folder driver folder under ICD2 under MPLAB IDE.
the path if default installation is used will be some thing like this
.../program files/Microchip/MPLAB IDE/ICD2/Drivers.
If you are using USB to power up ICD2 then you don't have to worry. I was searching for drivers every were else and then realized it is MPLABs baby. Note , some low quality USB cables have issues , so try changeing it too. You don't need to plug UDB to ICD2 for MPLab to resolve this issue.
cheers
Morli
Reply all
Reply to author
Forward
0 new messages