Maximum weights
73 views
Skip to first unread message
David V
Oct 26, 2019, 11:45:43 AM10/26/19
to Thor: OpenSource 3D printable Robotic Arm
Dear Angel and comunnity. I've got a few doubts. I'm mounting my Thor and thinking on potential improvements.
First of all, which is the weight of the whole arm? And then I'm wondering whether if we apply some optimization in all the printed parts so that we could reduce around a 30% of the whole arm weight, could we be able to have a higher payload?
First of all, which is the weight of the whole arm? And then I'm wondering whether if we apply some optimization in all the printed parts so that we could reduce around a 30% of the whole arm weight, could we be able to have a higher payload?
Many thanks and best regards
David
Angel LM
Oct 26, 2019, 1:29:31 PM10/26/19
to Thor: OpenSource 3D printable Robotic Arm
Hi David!
I'm not sure about the total weight of Thor... I would have to check it.
About the optimization, it sounds great. Of course we would be able to increase the payload by reducing the arm weight. I designed Thor without caring too much about the printed pieces weight, so it could be a very nice improvement!
About the optimization, it sounds great. Of course we would be able to increase the payload by reducing the arm weight. I designed Thor without caring too much about the printed pieces weight, so it could be a very nice improvement!
Best regards,
Ángel LM
Reply all
Reply to author
Forward
0 new messages