Cdr To Ezcad Converter

[Mette Florida]

On top you see the XYZA axis controllers
A for rotary
Z for lifting column
XY for motorized XY table.



Here is my fiber laser case with top lid and side panel removed.
You can see the old ezcad2 card on top.

I unplugged all connections from the old board and removed
the ezcad2 controller.

I had a thin aluminum sheet that I made holes for the new controller.



Here is the new controller installed in my machine and plugged in.
It is really Plug'n'Play
I had to solder the DB9 connector for my motorized z axis and rotary.
BJJCZ should have these prewired with a 40 cm cable.
The install have been even faster hehe


DB9 XYZA wiring diagram (ONE DRIVE FOR EACH AXIS)
You need to wire each axis like the diagram.



Here is my machine finished and tidy up cables.

I think it took around 20 minutes from I started to I was finished
installing the ezcad 3 controller.
But it will take a bit longer if you dont have the motorized Z-axis.
Look at my motorized zaxis build here