Cannot load the default image from Technexion

[kostas...@hotmail.gr]

Hi,
i m loading the default image for thunder board in an SD card, I put
the card in the board;s slot, the system is loading the image but when
i am rebooting I am getting the following error and the procedure
stops:

hub 1-2:1.0: USB hub
found
hub 1-2:1.0: 4 ports
detected
regulator_init_complete: incomplete constraints, leaving VDVI
on
regulator_init_complete: incomplete constraints, leaving VDAC
on
drivers/rtc/hctosys.c: unable to open rtc device
(rtc0)
clock: Could not find divisor for target rate 0 for clock dpll4_m5_ck
parent dpk
omap3isp omap3isp: clk_set_rate for dpll4_m5_ck failed

the procedure stops here
These are messages from the serial debug.
Regards
Kostas

[kostas...@hotmail.gr]

The image from the original webpage of TechNexion didnt work for me.
But finally I managed to overcome this problem using the Rescue image
from TechNexion.
So, download the image from the webpage,
use image-writer to burn the image in an SD card
boot the board witt this SD card
connect the Ethernel to the board
and then download the image from there (you have some option in the
device)

[Ash]

Hi 

I had similar problems regarding this. I wish Technexion would have updated their website or provided some documentation.