multiple SSID

[David]

Can't get tasker (State Edit) to pick multiple SSID.Not good when  auto switching between multiple wifi connections depending on their connection strength.

[Matt R]

Switching the connection based on the signal strength is non-trivial and I believe requires frequently polling the data in %WIFII. What logic are you using that you think should be working? You can't merely specify two access points and have Tasker automatically switch between the two (natively).

Matt

[UncleMike]

If you're trying to enter multiple SSIDs in a Wifi Connected or Wifi Near state, just type them in manually, separated by a slash for pattern matching.

[Ray Maxey]

I hope this applies to your situation, but I use this profile for multiple SSID's works like a charm...

http://tasker.wikidot.com/yanawa

[Wes Stacey]

I think that is the issue. It would be nice to be able to pick one from the list add a slash to the end then be able to pick another one from the list, especially for mac addresses which are much more difficult to enter manually.

[Matt R]

A bit better than typing manually of course would be pick one, select and copy, pick another, type slash and then paste, select all and copy again, pick another, slash and paste, etc...

Matt

[UncleMike]

Selecting contacts in appropriate contexts works this way - you can continually pick and add to the list.  It would be nice if SSID selection (or in any field that supports multiple values through pattern matching) worked this way as well.

[Pent]

>I think that is the issue. It would be nice to be able to pick one from the list add a slash to the end then be able to pick another one from the list, especially for mac addresses which are much >more difficult to enter manually.

I changed it to work like the contacts selection (an extra selection adds a slash and then the new entry)

Pent