Zb-01 Ice Maker Manual

[Melanie Wendelberger]

WaterSupply Pipe InstallationEnsure the sewer that will be used for draining is clean and unblocked.Connect the water tap connector seal to the tap.Connect the water tap connector to the water tap.Connect the 1.5m water supply pipe to the water tap connector.Install the filter using the included water filter brackets (optional).Connect the 2.0m water supply pipe to the filter (if installed).Connect the water supply valve connector seal to the water supply valve connector.Connect the water supply valve connector to the water supply valve.Water Discharge Pipe InstallationThe water discharge pipe (820mm in length) comes pre-installed on the back of the icemaker.Extend the pipe and connect it to the sewer.Ensure the highest point of the discharge pipe is higher than the sewer to prevent backflow.Leg AdjustmentTwist the two legs to adjust their height until the icemaker is level.Screw down the two adjustable legs into the nuts on the icemaker to secure them in place.OperationIcemaking Process

The icemaking process involves several steps:The water pump starts pumping water through the icemaker into the evaporator to form the mold of the ice cubes.The condenser pumps refrigerant to cool the water down and turn it into ice.The sensor inside detects when the water has frozen to ice and regulates the thickness of the ice cubes.Manual Operation Mode

Ice can also be made using the manual operation mode button on the display. Follow the instructions in the Display section for details.Cleaning & Care

Before cleaning, remove any ice cubes from the cabinet and ensure the main power and tap are turned off.Troubleshooting

If you encounter any issues with the ZB-40 Commercial Ice Cube Maker, refer to the troubleshooting section in the user manual for assistance.FAQ

Q: Can the icemaker be used for residential purposes?

A: The ZB-40 Commercial Ice Cube Maker is designed for commercial use but can also be used for residential purposes if desired.Q: How often should the icemaker be cleaned?

A: It is recommended to clean the icemaker regularly to maintain optimal performance. Refer to the cleaning and care section in the user manual for detailed instructions.Q: Can I adjust the thickness of the ice cubes?

A: Yes, the sensor inside the icemaker regulates the thickness of the ice cubes. However, further adjustments can be made using the manual operation mode button on the display.

ZB-40

COMMERCIAL

ICE CUBE MAKERSAFETY & WARNINGSEnsure to read all warnings and instructions in this user guide prior to first use. Retain for future reference.

To avoid electric shock,do not allow water or any other liquid touch the plugs,Ensure all components are accounted for in the package. If any components are missing, contact for assistance.Ensure the distance between the air vents of the ice cube maker and the wall is more than 50cm.To prevent damage and water leakage, do not bend any of the pipes connected to this ice cube maker.WARNING

Note:

To prevent the discharged water flowing back into the icemaker, ensure the highest point of the discharge pipe is higher than the sewer.Adjusting the legs

Adjust the two legs by twisting them until the icemaker is level. Screw down the two adjustable legs into the nuts on the icemaker.

Powering on Switch on the power to the icemaker by pressing the power button on the display.Turn on the tap and water supply valve. Fill the icemaker sink with water.Water pressure balancing

Upon first use, the icemaker will then automatically go through a process using the water supply, water pump and pre-installed drain valve to balance the water pressure in the machine. This process will take around 5 minutes. Usually, the machine is connected to the power source continually.

3a8082e126