auto receive
Eero M
> I am a loyal user of WinFax because it works so easily with other
> programs in my system. But I have just bought a Gateway system with a
> U.S. Robotics 56k voice modem, I have installed WF pro 8.0 but I can
> receive a call once and it will not answer a call again unless I
> reboot or turn auto receive off then on again. ( even that doesn't
> always work )
> It seems like the modem does not reset to the ready to receive mode
> after it picks up and hangs up a call.
>
If you select the "Modem" option from the Setup menu in WinFax Pro, you can highlight the modem you are using for faxing and click
on the Properties button to bring up the properties for that modem. In there on the General tab, a field for selecting the port
your modem is using for faxing. Change this from TAPI to COM X where 'X' is the COM port of your modem. Don't forget to click
"Apply" and "Ok" and then "Apply" and "Ok" again to get back to the WinFax Pro program with the new changes activated.
--
Thank you,
Eero M. [Symantec Corp.]
Please continue to post your messages to the public discussion groups as Symantec does not provide support via private e-mail.
If you have difficulty getting a response, please read the following article:
http://service1.symantec.com/SUPPORT/sharedtech.nsf/docid/1998527114414
For free technical support newsletters, Knowledge Base support articles, our Online Support Genie, and FAQs, visit our WinFax Pro
support page:
http://www.symantec.com/cgi-bin/menu.cgi?URL=%2Ftechsupp%2Fwinfax%2Fallservices_winfax.html
----