Invalid disk table in boot record
Vernon Balbert (Symantec)
>Configuration Information:
> Version: NU95 version 3.x
> Operating system: Windows 95b
>
>Hi I keep getting the "Invalid disk table in boot record" message
>when i try to scan my zip drive, an internal IDE drive. NDD in dos
>mode doesn't detect anything. I keep getting this message regardless
>of wether or not the disk is empty or full. Also if I can choose to
>correct this and then rerun NDD I get the same message over again.
>Any Ideas on how to fix this would be greatly appriciated.
Zb,
Can you please go to this URL and run the test on your computer to see
if you are running one of the defective controller card drivers?
http://www.symantec.com/nu/promise.html
Please let me know the results.
Good Luck!
Vernon Balbert
Senior Support Analyst
Symantec Corporation
Please continue to post your messages to the public discussion groups as
Symantec does not provide support via private e-mail. If you have
difficulty getting a response or in using our discussion groups, please
read the following article:
http://service1.symantec.com/SUPPORT/sharedtech.nsf/docid/1998527114414
For technical support newsletters, Knowledge Base support articles, our
Online Support Genie, and FAQs, visit our Norton Utilities support page: