Transfer command

[Zé Pedro Ramião]

Dear all,

I'm trying to use the transfer command to move water between reservoirs

I followed the intructions in the SWAT documentation and from previous discussions in this group. I added the transfer command after the routeres of the source reservoir, and before the routres of the sink reservoir in the fig.fig file. 

route          2    63     3    62

          000030000.rte000030000.swq

routres        3    64     1    63

          000030000.res000030000.lwq

transfer       4    2      1    2     3 00.950   1     1

          1   12    64

I found that water is removed from the source reservoir because its volume decreased considerably when including the transfer command, but the flow-in and the volume of the sink reservoir was not affected. I tried to i) transfer the water to the reach flowing to the sink reservoir, or to the reach upstream the sink reservoir ii) add the transfer command at the end of the fig.fig file, after the routeres of both reservoirs

The volume and flow-in of the sink reservoir were still not affected, even when I changed the percentage of water transfered

I'm using rev. 670

If you could help I would really appreciate

Thanks

Best wishes,