SWATplusR performing model

[6103...@qq.com]

Hi everyone,

When I am performing SWAT+ run in R, there is an error (as shown in the figure attached).

Should I configure some parameter to generate the corresponding files in SWAT+ Editor first? 

If anyone came across the same question as me?

Thanks in advance!

Eva

[Somsubhra Chattopadhyay]

I think you are calling the wrong file, you should have file = "channel_sd' instead of channel

Hope this helps, and if it does please confirm in the group!

Som

--
You received this message because you are subscribed to the Google Groups "SWAT+" group.
To unsubscribe from this group and stop receiving emails from it, send an email to swatplus+u...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/swatplus/25bd95b5-6d2b-47c9-9cca-c81d0b5a9d3an%40googlegroups.com.

--

Somsubhra Chattopadhyay, Ph.D

Postdoctoral Research Associate

Civil Engineering Department 

Warsaw University of Life Sciences, Poland

Cell: +48517023496

[6103...@qq.com]

Thanks Som,

I try your method and the procedure ran successfully.

But I checked my print.prt file, both channel and channel_sd were printed and there were "flow_out" variables in these files.

And I would like to ask how I should select these files?