forrtl: severe (408): fort: (11): Subscript #1 of the array CHEMAPP_DB has value -842150451 which is less than the lower bound of 0

6103...@qq.com

unread,

Jun 28, 2021, 4:08:55 AM6/28/21

to SWAT+

Dear all,

I have this error while I'm running swat+ in Editor,

Does anyone know how to fix this?

Thanks in advance.

Eva

forrtl: severe (408): fort: (11): Subscript #1 of the array CHEMAPP_DB has value -842150451 which is

less than the lower bound of 0 Image PC Routine Line Source rev60.5.2_64debug 00007FF7D3F66F9C Unknown Unknown Unknown rev60.5.2_64debug 00007FF7D3862D34 PL_FERT 63 pl_fert.f90 rev60.5.2_64debug 00007FF7D33599C1 ACTIONS 267 actions.f90 rev60.5.2_64debug 00007FF7D3DE94DC HRU_CONTROL 157 hru_control.f90 rev60.5.2_64debug 00007FF7D3C084B6 COMMAND 219 command.f90 rev60.5.2_64debug 00007FF7D3D1CCE9 TIME_CONTROL 224 time_control.f90 rev60.5.2_64debug 00007FF7D3472321 MAIN__ 78 main.f90 rev60.5.2_64debug 00007FF7D40358BE Unknown Unknown Unknown rev60.5.2_64debug 00007FF7D4036589 Unknown Unknown Unknown rev60.5.2_64debug 00007FF7D40364AE Unknown Unknown Unknown rev60.5.2_64debug 00007FF7D403636E Unknown Unknown Unknown rev60.5.2_64debug 00007FF7D40365F9 Unknown Unknown Unknown KERNEL32.DLL 00007FFDB47B7034 Unknown Unknown Unknown ntdll.dll 00007FFDB53A2651 Unknown Unknown Unknown

Natalja C.

unread,

Jun 28, 2021, 4:18:27 AM6/28/21

to SWAT+

Hello,

It seems to be an issue with fertilization, either in management of in the DTs.

Do you have DTs? Try to remove them and see if the error appears?

If not - check your management operations, especially when you apply fertilizers. Are all the used fertilizers in the database?

I always, I might be mistaken, and the error is berried deeper :)

Let us know how it goes,

Natalja

6103...@qq.com

unread,

Jun 28, 2021, 8:05:06 AM6/28/21

to SWAT+

Hi, Natalja,

Thanks for your reply!

I reconstructed my SWAT+ model, and try the managements one by one.

I find when I apply the DT fert_rot_1, the same error will occur. But when I try the DT fert_sprg_side, the model can run successfully.

The differences between the two DTs are as the figure below:

How should I understand the difference between these parameters? As I haven't use decision table before.