Swat+ toolbox installation problem

[Birhanu Legesse]

Dear All,

I can't install the swat+ toolbox on my pc.  It says ' Swat+ toolbox cannot be installed on system with screen resolution smaller than 1280x1024.'

and I cannot go for a pc with a higher screen resolution due to financial problems. 

What do you advise me to carry out calibration, sensitivity analysis, and ... in SWAT+?

Thank you for any supporting ideas. 

Birhanu, (from Ethiopia, Africa)

[Michael Haile]

Dear Birhanu,

You must be trying to install the latest version (SWAT+ toolbox 1.0). You cannot install that in your pc with resolution you have. 

I face the same problem. But I am using SWAT+ toolbox v0.7.6 with resolution 1366x768.

Therefore, SWAT+ toolbox v0.7.6 will work well for your pc.

good luck

Michael Haile

[Roberto Angel Olmos]

I was facing the same problem, the solution I found was the following:
- Connect a TV screen with an HDMI cable
- Within screen settings, select the added monitor as the main screen.
- Save settings
- Install Toolbox
- After installation, return the screen configuration to the initial situation, changing the main one again.

With this you can already use Toolbox.
CONSIDERATIONS
- Windows will trim the excess edge of the screen so the minimize, maximize and close buttons will not appear.
- The start bar will be hidden when you are using Toolbox so you must press start so that it appears every time you have to use it.
- Due to the resolution, the graphs of observed variables will not be adequately appreciated.
I hope it helps you.

[shimelash molla]

Dear all,

Did you get any solution for your questions above. I faced the same problem.  Thanks

[Agene Isaac]

Same thing, mine wont show all whether I minimize or maximize