Seeking Guidance on SWAT+ CUP Ver 3.0; SPE_run Problem (No Output Files)
issao...@gmail.com
Hello everyone,
I hope this message finds you well.
I am currently encountering a persistent issue when running SWAT+ CUP version 3 and would greatly appreciate any insights or advice from the community.
Following earlier suggestions from 2W2E team, I have already:
· Replaced the contents of my working directory with those from the Backup folder (to rule out corrupted or missing files).
· Restricted the request to only essential output files.
· Tested the procedure with all available SWAT+ executables, including the version that previously worked for me in SWAT+ Editor v3.0.8.
Unfortunately, these steps have not resolved the issue.
To illustrate, I prepared two simple test cases (calibration input files, batch files, and screenshots are attached for the reference):
· Case 1: One parameter, one simulation.
· Case 2: Seven parameters, fifteen simulations.
In both cases, the SPE_pre step executes successfully. However, when running SPE_run, the process finishes without any visible errors, yet SWAT+ does not generate the requested output files (e.g., channel_sdmorph_day as defined in Print.Prt). Because of this, subsequent steps such as SPE_Single_Obj_post and SPE_No_Obj_Obs_Post cannot be executed properly.
Has anyone experienced a similar issue or found a workaround? Please let me know if further details or files would be useful for diagnosis.
Many thanks in advance for your time and support.
Kind regards,Issa
Mario Fomaca Jr
--
You received this message because you are subscribed to the Google Groups "SWAT-CUP" group.
To unsubscribe from this group and stop receiving emails from it, send an email to swat-cup+u...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/swat-cup/b00af84a-26f0-4711-b8de-d6ae3063c287n%40googlegroups.com.
Marionei Fomaca Jr
Geospatial Data Scientist
Agricultural and Environmental Engineer