RSeQC results to set -s parameter for featureCounts

52 views
Skip to first unread message

Tonja Rand

unread,
Jan 6, 2016, 6:58:58 AM1/6/16
to Subread
I have RNAseq data from encode mouse and to do some analysis with cuffdiff and featureCounts I need first to understand what library type I have to chose the right parameters for featureCounts.

I ran infer_experiment.py from RSeQC and found out following configuration:
 This is SingleEnd Data
Fraction of reads failed to determine: 0.0023

Fraction of reads explained by "++,--": 0.0160

Fraction of reads explained by "+-,-+": 0.9817




For featureCounts I need to specify -s parameter. It would be -s2, is it correct?

Wei Shi

unread,
Jan 6, 2016, 5:24:36 PM1/6/16
to Subread
I do not know what -s value you should use from the Rseqc output. But you may try all three different values (0, 1 and 2) to see which one gives you reasonable counting results. Each run should only take around a minute.

Cheers,
Wei

王紫仪

unread,
Aug 27, 2019, 11:17:50 AM8/27/19
to Subread
You should use -s 2 the reversed library.
Reply all
Reply to author
Forward
0 new messages