Iso 6336-5

0 views

Skip to first unread message

Gaetane Eary

unread,

Aug 3, 2024, 5:23:22 PM8/3/24

to stutnaltclanweb

ISO 6336-5:2016 describes contact and tooth-root stresses and gives numerical values for both limit stress numbers. It specifies requirements for material quality and heat treatment and comments on their influences on both limit stress numbers.

Almost done!
You are only one step away from joining the ISO subscriber list. Please confirm your subscription by clicking on the email we've just sent to you. You will not be registered until you confirm your subscription. If you can't find the email, kindly check your spam folder and/or the promotions tab (if you use Gmail).

L'ISO 6336-5:2016 dcrit les contraintes de pression de contact et les contraintes en pied de dent, et donne des valeurs numriques pour ces deux contraintes limites de rfrence. Elle spcifie les exigences pour la qualit du matriau et le traitement thermique, et elle fournit des indications concernant leur influence sur chacune des contraintes limites de rfrence.

Le prsent document fait partie d'un ensemble de normes donnant des mthodes de calcul de la capacit de charge des roues cylindriques denture intrieure ou extrieure et profil en dveloppante de cercle.La prsente partie spcifie les mthodes pour la dtermination des contraintes admissibles et les exigences pour la qualit des matriaux et du traitement thermique.

ISO 6336-5:2003 describes contact and tooth-root stresses, and gives numerical values for both limit stress numbers. It specifies requirements for material quality and heat treatment and comments on their influences on both limit stress numbers. Values in accordance with it are suitable for use with the calculation procedures provided in ISO 6336-2 and ISO 6336-3 and in the application standards for industrial, high speed and marine gears. They are also suited to the calculation procedures given in ISO 10300 for rating the load capacity of bevel gears. It is applicable to all gearing, basic rack profiles, profile dimensions, design, etc., covered by those standards. The results are in good agreement with other methods for the range indicated in the scope of ISO 6336-1.