Issue with SWAT+ Toolbox Sensitivity/Calibration

Tulsi Ram Pokhrel

unread,

May 20, 2025, 7:12:09 PM5/20/25

to SWAT+ Toolbox

Hi SWAT+ Developers,

I was previously able to run sensitivity analysis and calibration smoothly using the SWAT+ Toolbox. Later, I updated my base model by incorporating lakes and changing the PET method to Priestley-Taylor. After these modifications, I noticed an updated SWAT+ Toolbox version (v3.0.7) and decided to test the updated model there. Initially, the model ran successfully.

However, when attempting to run sensitivity analysis or calibration, the Toolbox became unresponsive and eventually crashed without producing results. I'm looking for guidance on identifying potential reasons for this issue; could the introduction of lakes, the PET method switch, or perhaps something related to the new Toolbox version be causing this problem?

I'd appreciate any insights or suggestions you may have.

Thank you

Tulsi

Celray James

unread,

May 20, 2025, 7:13:06 PM5/20/25

to SWAT+ Toolbox

I have some time to look into this right now, mind sharing your project?

Celray James

unread,

May 23, 2025, 1:07:39 PM5/23/25

to SWAT+ Toolbox

I have received your project, looking into it.

Reply all

Reply to author

Forward