Sensitivity and calibration problems
Milkessa Gebeyehu Homa
Subject: Issue Running Sensitivity Analysis and Calibration in SWAT+ Toolbox
Hello Celray,
I have been struggling to run the sensitivity analysis in SWAT+ Toolbox using the latest version. The process begins normally but stops progressing after reaching a certain percentage. After waiting for about six hours with no further progress, I stopped and then resumed the analysis. It continued for a while but stalled again. I repeated this stop‑and‑resume approach, and although it eventually completed, the final results were nonsensical. I’ve attached a screenshot of the output so you can see what it looks like.
Following this issue, I proceeded to run the calibration, but it immediately showed an error, which I’ve also attached.
Could you please take a look and share your thoughts on what might be causing these problems and how I can get the sensitivity analysis and calibration to run smoothly and produce meaningful results?
Looking forward to your insights.
Best regards,
