How to use Tasmota ir to send reVox ir codes

[Yalp Vriend]

Hi all,

don't know if this is the right place but otherwise someone might be able to point me in the right direction.

I have a UFO-R1 flashed with Tasmota-ir and can send commands for my beamer but I'm struggling to take control of my reVox amp. I don't have the original remote and all the codes I can find are in Pronto Hex. I tested a few of them after converting them to Raw with no luck but recently found a post with different codes and the explanation that reVox uses umodulated IR signals (http://www.remotecentral.com/cgi-bin/mboard/rc-pronto/thread.cgi?keywords=6430&highlight=revox%7Cpronto%7Chex) and I don't have a clue how I would be able to send it with Tasmota. Anyone any one any idea, or ideally experience with this use case?

The general resource about converting Pronto ir codes doesn't extend to unmodulated signals (that are indicated by the starting hex 0100 instead of the modulated 0000) https://tasmota.github.io/docs/IRSend-RAW-Encoding/#converting-pronto-ir-codes-to-tasmota.

The first value in the Raw send feature is the frequency but with an unmodulated signal this is 0kHz (as far as I understand it), but the 0 value is the default option for 38kHz which makes it impossible to give the value 0.

Kind regards,

Grit