Sonoff RF Bridge programming

[Simon]

I flashed my new Sonoff RF Bridge and its working fine as far as that device goes. How do I get this remote to link to it?  I can see the commands, and the first time I sent a 2 to RfKey it beeped but now nothing..

Sonoff RF Bridge 433

Command	Payload	Description
RfKey<x>		Send learned or default RF data for RfKey1 to RfKey16
RfKey<x>	1	Send default RF data for RfKey1 to RfKey16
RfKey<x>	2	Learn RF data for RfKey1 to RfKey16
RfKey<x>	3	Unlearn RF data for RfKey1 to RfKey16

What should I send / press on the remote? My remote works with my Sonoff RF and it does actually pickup when I press the first button. I want it to learn the next 3x.

[Yusri Salleh]

u type "RfKey1 2"   minus the "" to configure  button 1 on sonoff landing web interface. then u press your remote button.  then bridge will learn that command. next time u can just press button 1 at the main page to replay your remote

[K Smith]

I am trying to pair my remote with the sonoff rf.

When I enter "RfKey1 2" without the " " in either the Web console, the MQTT command or the web url, I get nothing back. 

I have also pressed the ob board button quickly twice so that it flashes red. I then press the remote button and the sonof rf does not blink red 3 times to indicate it has sucked up the code.

The rf remote they use is a standard 433Mhz remote.

I know the one I have programmed is programmed with 24-bits serial, mixture of high-to-low or low-to-high each forming a 1 or 0 serial radio signal.

I think the sonoff is looking for a particular starting code sequence.

Simon can you sniff the code off your remote and publish it's characteristics?

Thanks