Need some help with controlling my skylight window Rf Bridge +Tasmota+Portisch

[Dror Yaniv]

Hello ,

I have a Sonff RF bridge with Tasmota and Portisch firmware where I try to control a skylight window.

While being successful for few occasions , most of the times it just don't do anything .

While analyzing the protocol is seems that code is identical while what changes are bucket times.

When trying to control a RF ceiling fan I can trigger it off and on but it takes few attempts till it is working .

I wonder if there's any ability to better debug if my unit is defective ?

Might it be that a different configuration is needed ?

Can it be that code is too long ?

Any help will be highly appreciated

In the bottom you can see some codes where I do rfraw 177 and press the RF remote for ~3 secs

"RfRaw":{"Data":"AA B1 05 01CC 0136 0F0A 0348 602C 4818181818181818180808080808080808080808080808280B080838080B3B08083808080B08080838080808080B083B380B0838080B08380B080838080B0808083B0808380B080838080B 55"}}

"RfRaw":{"Data":"AA B1 05 01E0 012C 0F00 0348 5FB4 4818181818181818181818181818181818181818181818280B181808181B0B18080808080B08080808080808080B083B380B0838080B08380B080838080B0808083B0808380B080838080B 55"}}

I am using the following converter https://bbconv.hrbl.pl/
Conversion resulted in the following codes :

 I sent from bridge 3 different examples

rfraw AA B0 53 05 08 01CC 0136 0F0A 0302 5E9C 48181818181818180808080808080808080808080808082808380B3808080B38080B08080838080B38080B08083B3B3B380B380B080808380B3B3B3B083B08380B380B38080808 55

RfRaw AA B0 58 05 08 01D6 012C 0F00 02F8 5E4C 481818181818181818181818180818181818081818180828080808080808380B080838080B083B080808083B083B0808380B3B380B3B080808080808380B3B08080838080B08080808083808 55

RfRaw AA B0 54 05 08 01CC 0136 0F0A 02F8 5E88 48181818181818180808080808080808080808080808082808080808380B3B08083B083B3B0808380B08083B083B08083B38080B3B080808083B08083B0808083B3B080808380B38 55

  

Any insights would be great