Sonobus (standalone) not receiving input even though all routing is correct
6 views
Skip to first unread message
Mannan Alawar
May 7, 2026, 10:44:41 AMMay 7
to SonoBus Users
Hi everyone, I’m having trouble getting my guitar signal into the standalone Sonobus application and would appreciate any help.
My setup is:
Guitar > Kemper Main Out > Input 8 on Apogee Symphony MkII
The Symphony MkII is connected to my PC via Dante (Marian Clara E Card)
Routing is done in Dante Controller, where MKII inputs are correctly mapped to Clara-E inputs
To confirm this, I can firstly see the guitar signal coming into the Symphony MkII display. And, I can see signal coming through on the expected input channel over my DAW, so Dante routing seems to be working fine.
However, I'm not getting any signal coming through to Sonobus standalone application.
Settings:
Audio device: ASIO
Device: Clara E
Input channels: 7–8
Sample rate: 48 kHz
Appreciate any support - Thanks in advance!
My setup is:
Guitar > Kemper Main Out > Input 8 on Apogee Symphony MkII
The Symphony MkII is connected to my PC via Dante (Marian Clara E Card)
Routing is done in Dante Controller, where MKII inputs are correctly mapped to Clara-E inputs
To confirm this, I can firstly see the guitar signal coming into the Symphony MkII display. And, I can see signal coming through on the expected input channel over my DAW, so Dante routing seems to be working fine.
However, I'm not getting any signal coming through to Sonobus standalone application.
Settings:
Audio device: ASIO
Device: Clara E
Input channels: 7–8
Sample rate: 48 kHz
Appreciate any support - Thanks in advance!
Reply all
Reply to author
Forward
0 new messages