Lots of syntax errors in examples

[Scott]

Hi,

Just put together my new demo kit (cpu, lcd, sensors, etc.) and have connected to it with Telnet and loaded and run a few demos.  I am getting lots of syntax errors typing in examples from the CoreBASIC pdf and in examples I've loaded.

For example, 3d-cube-1, loads, but when run reports syntax errors in 1010:

1010 for i = 0 to high ax

There are also several other instances of the same syntax problem with the high function in 1180.

Also, "firmware check" reports a read error.  I did run "|upgrade" a couple of times.  Both runs reported success.

Thanks,
Scott

[Scott]

I see the problem.  The loaded firmware is version 0.9.5.  I just need to load a newer version of BASIC and these problems will likely be resolved.

Scott