Teknic Servo/Stepper wiring CPM-SDSK-2311S-RLN

[electrow...@gmail.com]

Hello, 

I have been trying to get a hold of panucatt but it is impossible, can someone give me a hand here. I am trying to wire a set of teknic motors my friend gave me to the Azteeg X5 gt board. Just want to make sure the wiring is ok. Model CPM-SDSK-2311S-RLN

Attached is a picture, Thank you for your time and help

[Jetguy]

No do not bond signal ground to power ground. 

Your grey wiring from the signal connector should be connected to the same ground pin in the boards pin row as the other signals (step, dir, enable). 

Most every driver is onto-isolated, so again, absolutely zero reason to connect as drawn and connecting as drawn you run serious risk of ground loops and other issues.

[electrow...@gmail.com]

Thank you so much! there is no need for a 5V connection right? 

[Jetguy]

No, 5V is not required.

[Jetguy]

On Tuesday, July 3, 2018 at 6:34:50 PM UTC-4, electrow...@gmail.com wrote:

[electrow...@gmail.com]

Very kind, Thank you so much for your help. 

On Tuesday, July 3, 2018 at 6:34:50 PM UTC-4, electrow...@gmail.com wrote:

[electrow...@gmail.com]

Hello everyone, 

One more question I forgot to ask, can both motors be wired to the same pins? to drive a dual X?

[Arthur Wolf]

How much current do each of the inputs consume ?

--
You received this message because you are subscribed to the Google Groups "Smoothieware Support" group.
To unsubscribe from this group and stop receiving emails from it, send an email to smoothieware-sup...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

--

Courage et bonne humeur.

[electrow...@gmail.com]

8mAmp @ 5v I believe 

[Arthur Wolf]

You might need a level shifter inbetween then, check the LPC1769 for th current rating of the pins

On Wed, Jul 11, 2018 at 4:11 PM <electrow...@gmail.com> wrote:

8mAmp @ 5v I believe 

--
You received this message because you are subscribed to the Google Groups "Smoothieware Support" group.
To unsubscribe from this group and stop receiving emails from it, send an email to smoothieware-sup...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

[electrow...@gmail.com]

Thank you!

[Ronald Gilmore]

hey electrow, i too am trying to connect teknic clearpath motor to a Azeeg X5 GT and i am not having any luck, have you got it working and if so could you tell me how you went about doing so, i have CPM-SDSK-2310S-RQN but they are mechanically the same motor.... any help would be great thankyou 

[Jetguy]

[electrow...@gmail.com]

Hello everyone, 

SInce my friend never gave me the motors I had to save up to buy them. 

I have finally got them, wired, auto-tuned and everything worked fine. Unfortunately once I wire to the Azteeg board I am unable to communicate with the motors. do I have to change anything in the firmware or activate any feature on the teknic software? 

Thank you in advance for any help